Skid Marks
   HOME

TheInfoList



OR:

A skid mark is the visible mark left by any solid which moves against another, and is an important aspect of
trace evidence Trace evidence is created when objects make contact. The material is often transferred by heat or induced by contact friction. The importance of trace evidence in criminal investigations was shown by Dr. Edmond Locard in the early 20th century. ...
analysis in
forensic science Forensic science, also known as criminalistics, is the application of science to criminal and civil laws, mainly—on the criminal side—during criminal investigation, as governed by the legal standards of admissible evidence and criminal ...
and
forensic engineering Forensic engineering has been defined as ''"the investigation of failures - ranging from serviceability to catastrophic - which may lead to legal activity, including both civil and criminal".'' It includes the investigation of materials, product ...
. Skid marks caused by tires on roads occur when a vehicle wheel stops rolling and slides or spins on the surface of the road. Skid marks can be analyzed to find the maximum and minimum vehicle speed prior to an impact or incident.
Skid __NOTOC__ Skid or Skids may refer to: * Skid, a type of pallet * Skid (aerodynamics), an outward side-slip in an aircraft turn * Skid (automobile), an automobile handling condition where one or more tires are slipping relative to the road * Skid, ...
ding can also occur on
black ice Black ice, sometimes called clear ice, is a thin coating of glaze ice on a surface, especially on streets. The ice itself is not black, but visually transparent, allowing the often black road below to be seen through it. The typically low levels ...
or
diesel Diesel may refer to: * Diesel engine, an internal combustion engine where ignition is caused by compression * Diesel fuel, a liquid fuel used in diesel engines * Diesel locomotive, a railway locomotive in which the prime mover is a diesel engin ...
deposits on the road and may not leave a mark at all.


Characteristics

Skid marks are divided into "acceleration marks" created on acceleration, if the engine provides more power than the tire can transmit; "braking marks", if the brakes "lock up" and cause the tire to slide; or " yaw marks", if the tire slides sideways. Each skid mark has a characteristic appearance, and an experienced accident reconstructor or forensic engineer can often determine what the vehicle was doing by examining the marks left by the tire. Different road surfaces produce different kinds of skid marks, sometimes also referred to as ''scuff marks'' or ''tire marks''. On asphalt road surfaces, skid marks are usually the result of bituminous oils in the asphalt that are heated because of the friction of braking or accelerating and rise to the surface, leaving dark marks.Carty, G. Collision Reconstruction. Nov 3, 2016. Mississauga, ON : University of Toronto Mississauga. This kind of mark on asphalt can last for months or even a year or two if they are particularly dark and the roadway is not well traveled. On other road surfaces, such as concrete, the marks result from the deposition of tire compounds onto the surface of the roadway. This kind of skid mark is typical of airport runways, which need to be periodically cleaned to remove deposited debris that reduce the frictional coefficient of the runway.D.P. Eisenbeisz, Wikipedia Talk response. June 28, 2008.Miranda, M. Tire Marks & Their Role in Accident-Reconstruction Investigations. Jan 8, 2018. PInow.com. The durability of these marks depends on a number of factors, including road use, tire compounds, weather, and frequency of road cleaning. Braking marks will vary depending on whether the car uses ABS or not. If not, there will be two lines. The darker marks on the outside are from the front wheels, while the back tires leave thinner marks. This is because the force exerted makes the wheels take on a conical shape. If the car uses ABS, the marks will be much fainter as less heat is produced by the release-stop mechanism of ABS. Scuff marks may be visible however with ABS. The term "scuff mark" is more often used for marks left by rubber
shoe A shoe is an item of footwear intended to protect and comfort the human foot. They are often worn with a sock. Shoes are also used as an item of decoration and fashion. The design of shoes has varied enormously through time and from culture t ...
s on a floor, mainly sneakers or trainers leaving black rubber marks on a
gym A gymnasium, also known as a gym, is an indoor location for athletics. The word is derived from the ancient Greek term " gymnasium". They are commonly found in athletic and fitness centres, and as activity and learning spaces in educational ins ...
nasium floor or
basketball court In basketball, the basketball court is the playing surface, consisting of a rectangular floor, with baskets at each end. Indoor basketball courts are almost always made of polished wood, usually maple, with -high rims on each basket. Outdoor sur ...
when someone comes to a hard stop, or pivots in place, or a
hockey puck A hockey puck is either an open or closed disk used in a variety of sports and games. There are designs made for use on an ice surface, such as in ice hockey, and others for the different variants of floor hockey which includes the wheeled skate ...
leaving a rubber streak along the edge boards of the
rink Rink may refer to: * Ice rink, a surface of ice used for ice skating ** Figure skating rink, an ice rink designed for figure skating ** Ice hockey rink, an ice rink designed for ice hockey ** Speed skating rink, an ice rink designed for speed skat ...
.


Ladder accidents

Skid marks can also be formed where a
ladder A ladder is a vertical or inclined set of rungs or steps used for climbing or descending. There are two types: rigid ladders that are self-supporting or that may be leaned against a vertical surface such as a wall, and rollable ladders, such a ...
suddenly slips and the user falls to the ground, especially if the ladder feet are faulty or absent. Loss of the
rubber Rubber, also called India rubber, latex, Amazonian rubber, ''caucho'', or ''caoutchouc'', as initially produced, consists of polymers of the organic compound isoprene, with minor impurities of other organic compounds. Thailand, Malaysia, and ...
feet or foot causes the
aluminum Aluminium (aluminum in American and Canadian English) is a chemical element with the symbol Al and atomic number 13. Aluminium has a density lower than those of other common metals, at approximately one third that of steel. It has ...
stile to make contact with the ground, and if a hard surface like concrete or tiling, a skid mark shows how and why the ladder slipped. Unless fixed to the wall upon which they are leaning, ladders can slip down easily, especially if the ladder is leaned at an angle lower than about 75 degrees. Such slip accidents tend to happen when the user is near the top of the ladder, increasing his or her chances of serious
personal injury Personal injury is a legal term for an injury to the body, mind or emotions, as opposed to an injury to property. In common law jurisdictions the term is most commonly used to refer to a type of tort lawsuit in which the person bringing the suit (t ...
.


Accident reconstruction

Such marks are important evidence for
vehicular accident reconstruction Traffic collision reconstruction is the process of investigating, analyzing, and drawing conclusions about the causes and events during a vehicle collision. Reconstructionists conduct collision analysis and reconstruction to identify the cause ...
, when their size and shape can reveal much about vehicle speed and forces of acceleration or deceleration. They are one form of
trace evidence Trace evidence is created when objects make contact. The material is often transferred by heat or induced by contact friction. The importance of trace evidence in criminal investigations was shown by Dr. Edmond Locard in the early 20th century. ...
. They represent a form of contact evidence produced according to
Locard's exchange principle In forensic science, Locard's principle holds that the perpetrator of a crime will bring something into the crime scene and leave with something from it, and that both can be used as forensic evidence. Dr. Edmond Locard (1877–1966) was a pione ...
. The length of the skid mark is usually closely related to the vehicle speed at the instant of braking, so measuring the marks yields an estimate of original speed.


Modern slang

In modern
slang Slang is vocabulary (words, phrases, and linguistic usages) of an informal register, common in spoken conversation but avoided in formal writing. It also sometimes refers to the language generally exclusive to the members of particular in-gro ...
, the term "skid mark" means a
fecal Feces ( or faeces), known colloquially and in slang as poo and poop, are the solid or semi-solid remains of food that was not digested in the small intestine, and has been broken down by bacteria in the large intestine. Feces contain a relati ...
stain or smear on the back of one's
underwear Undergarments, underclothing, or underwear are items of clothing worn beneath outer clothes, usually in direct contact with the skin, although they may comprise more than a single layer. They serve to keep outer garments from being soiled o ...
. It may also apply to a pet experiencing anal irritation and sliding (or scooting) across the floor to relieve the itching or obstruction, leaving a line of feces behind.


See also

*
Braking distance Braking distance refers to the distance a vehicle will travel from the point when its brakes are fully applied to when it comes to a complete stop. It is primarily affected by the original speed of the vehicle and the coefficient of friction be ...
*
Forensic materials engineering Forensic materials engineering, a branch of forensic engineering, focuses on the material evidence from crime or accident scenes, seeking defects in those materials which might explain why an accident occurred, or the source of a specific materi ...
*
Forensic polymer engineering Forensic polymer engineering is the study of failure in polymeric products. The topic includes the fracture of plastic products, or any other reason why such a product fails in service, or fails to meet its specification. The subject focuses on t ...
*
Polymer degradation Polymer degradation is the reduction in the physical properties of a polymer, such as strength, caused by changes in its chemical composition. Polymers and particularly plastics are subject to degradation at all stages of their product life cycle ...


Notes


References


Further reading

*''Introduction to Forensic Engineering'' (The Forensic Library) by Randall K. Noon, CRC Press (1992). *''Forensic Engineering Investigation'' by Randall K. Noon, CRC Press (2000). *''Forensic Materials Engineering: Case Studies'' by Peter Rhys Lewis, Colin Gagg, Ken Reynolds, CRC Press (2004).


External links


Accreditation Commission for Traffic Accident Reconstruction (ACTAR)

National Highway Traffic Safety Administration

National Academy of Forensic Engineers
{{Tires, state=collapsed Tires Evidence law Forensic evidence